User manual

Range Hood / User Manual
13 / 62 EN
4 Installng your applance
4.2.2 Hang hood on wood
support
• Lift the hood and hold close to the installation
location. Route house wiring through the
knockout and into the junction box.
• Place the hood over the wood support. Be sure
the mounting screws engage the keyhole slots
in the back of the hood.
Tighten the screws.
A
WARNING: Continue to provide
additional support while the hood is
mounted with only these 2 screws.
These screws will not support the weight of the
hood. The hood could fall resulting in damage or
personal injury.
• Check to be sure the hood is level and centered.
30”
4.2.3 Install bottom mounting
screws
• Drill 1/8” pilot holes into the two lower mounting
holes. Enlarge the holes if they did not enter
studs to 3/8”. Insert anchors for wall fasteners
into bottom holes. Remove anchor screws and
add flat washers provided. Drive screws into
anchors and tighten.
• Install 4 additional screws through the back of
the hood and into the wood support.
4.3 İnstall hood ceiling or
beneath cabinets
(Skip this step if using wall mounting method)
A
IMPORTANT: Ceiling framing
must be capable of supporting up to
150 lbs.
• The ceiling should be constructed with 2x4’s.
• Determine the installation location on the wall.
• Continue the centerline forward on the bottom
of the cabinet or ceiling.
• The opening above the hood should allow for
the 10” round duct and clearance to slide the
hood back against the wall.
• The 2x4 studs must be located as shown in the
chart, Dim. A to accept monting screw.
• Drill 1/8” pilot holes into the studs at the
locations show in the illustration.