Installation Manual

Over The Range Convection Microwave Oven / Installation Manual
16 / 63 EN
Area E
Hole A
Hole B
Centerline
notches
Draw a Vertical Line
on Wall from Center
of Top Cabinet
Draw a Horizontal line on wall from
bottom of “Rear Wall Template”.
Horizontal Line
Horizontal Line
C
L
3/8" TO EDGE
NOTE: IT IS VERY IMPORTANT TO
READ AND FOLLOW THE DI
RECTIONS
IN THE INSTALLATION INSTRUCTIONS
BEFORE PROCEEDI
NG WITH
THIS
REAR WALL TEMPLATE.
This Rear Wal
l Template serves t
o position the bottom
mounting plate and to locate
the horizontal exhaust
outlet.
1. Use a level to check th
at the template is positioned
accurately.
2. Locate and ma
rk at least one stud on the left or
right side of the centerlin
e.
It is important to use at least one wood
screw mounted firmly in a stud to s
upport the weight
of the microwave. Mark two add
itional, evenly spaced
locations for the supplied toggle bolts.
3. Drill holes in the marked locatio
ns. Where there is
a stud, drill a 3/16" hole for
wood screws. For hole
s
that do not line up with a st
ud, drill 5/8" holes for
toggle bolts.
DO NOT INSTALL THE M
OUNTING PLATE
AT THIS TIME.
4. Remove the tem
plate from the rear wall.
5. Review the Installation Instru
ction book for your
installation situation.
Locate and mark
holes to align with h
oles in the
mounting plat
e.
IMPORTANT:
LOCATE
AT LEAST ONE
STUD ON EITHER SIDE OF
THE CENTERLINE.
MARK THE LOCATION FOR 2
ADDITIONAL, EVENLY
SPACED
TOGGLE BOLTS IN
THE MOUNTING PLATE
AREA.
Locate and mark
holes to align with hol
es in the
mounting plat
e.
IMPORTANT:
LOCATE
AT LEAST ONE
STUD ON EITHER SIDE OF
THE CENTERLINE.
MARK THE LOCATION FOR 2
ADDITIONAL, EVENLY
SPACED
TOGGLE BOLTS IN
THE MOUNTING PLATE
AREA.
Trim the rear
wall template al
ong the dotted
line.
12"
4"
Darle vuelta a la hoja para consultar la
versión en Español.
A
Wear gloves to avoid cutting fingers
on sharp edges.
5.1.4 Aligning the wall plate
1. Draw a Vertical line on the wall at the center of
the 30” wide space.
2. Draw a Horizontal line on the wall at the bottom
of “Rear Wall Template”.
3. Drill 5/8” holes for toggle bolts on 2 locations
(Hole A, Hole B) but if the location of hole is
same as that of stud, drill a 3/16” hole for wood
screw. In other words, toggle bolt can not be
used to the location of stud.
C
DO NOT MOUNT THE PLATE AT THIS
TIME.
5
Installation
C
Holes A and B are inside area E. If
both of A and B are not in a stud,
find a stud somewhere in area E and
draw a forth circle to line up with the
stud. It is important to use at least
one wood screw mounted firmly in
a stud to support the weight of the
microwave. Set the mounting plate
aside.