Installation Manual

11 / 63 EN
Over The Range Convection Microwave Oven / Installation Manual
4
External exhaust
45° Elbow 5 Ft. (1.5 m)
x ( ) = Ft. or m
Roof Cap 24 Ft. (7.3 m)
x ( ) = Ft. or m
Straight Duct 6“ (15.2 cm)
Round or
3
1⁄4
” x 10” (8.2 x 25.4
cm) rectangula
1 Ft. (0.3 m)
x ( ) = Ft. or m
Total Ductwork = Ft. or m
C
If a rectangular-to-round transition
adaptor is used, the bottom corners
of the damper will have to be cut to
fit, using the tin snips, in order to al-
low free movement of the damper.
C
For back exhaust, care should be tak-
en to align exhaust with space be-
tween studs, or wall should be pre-
pared at the time it is constructed by
leaving enough space between the
wall studs to accommodate exhaust.
4.2 Damage – shipment /
installation
• If the unit is damaged in shipment, return the
unit tı the store in which it was bought for repair
or replacement.
• If the unit is damaged by the customer, repair
or replacement is the responsibility of the
customer.
• If the unit is damaged by the installer /if other
than the customer), repair or replacement must
be made by arrangement between customer
and installer.
4.3 Parts included
4.3.1 Hardware packet
Part Quantity
Wood Screws
(1⁄4“ x 2“)
2
Toggle Bolts (and
wing nuts) (3⁄16“
x 3“)
2
Self-Aligning Machine
Screws
(1⁄4“-28 x 31⁄4“)
3
Nylon Grommet
(for metal cabinets)
1
You will find the installation hardware contained in a packet
with the unit. Check to make sure you have all these parts.
NOTE: Some extra parts are included.