Manualshelf

Specifications

ManualsBrandsBlodgett ManualsOvenSG2136 E & G
31323334353637383940
Maintenance
31
Troubleshooting Guide
POSSIBLE CAUSE(S) SUGGESTED REMEDY
SYMPTOM: Operator control display is blank and there is no power to the oven.
S
Power outlet is not live (new installations).
S
Oven not plugged in.
S
Emergency stop button is pushed in (remote
control oven only).
S
Fuse(s) are blown.
S
24 VDC power supply’s internal breaker tripped.
S
24 VDC power supply defective.
S
Have a qualified person ensure that the power
outlet is live.
S
Check that the power cord is connected.
S
Pull the button out to disengage the emergency
stop.
S
Unpug the oven power cord. Check t he 5A fuses
behind t he electrical box access door. Call ser-
vice if blown.
S
Unplug the oven pow er cord for 15 minutes.
Check the fuses then reconnect.
S
*
SYMPTOM: Conveyor belt will not run or stops. Display reads M OT O R FA ULT --- C ALL S E R VI C E .
S
Belt hooked on something in oven.
S
Belt overloaded.
S
Defectiveconveyordrivemotor.
S
Defectiveconveyordrivemotorcontroller.
S
Turn oven OFF. Unhook and resolve problem.
S
Remove product until the belt starts to move and
call service.
S
*
S
*
SYMPTOM: Operator control display is blank and the oven is on.
S
Connection at t he rear of the operator control
has come loose. The oven should continue to
run and respond to any faults, but the operator
control will not function.
S
Shut off manual gas valve. Once the oven has
cooled down unplug the oven and call service.
(SG2136G).
S
Press the emergency stop button and call ser-
vice (SG2136E). (remote control oven only)
*Denotes remedy is a difficult operation and should b e performed by qualified personnel only. It is recommended, however, that
All repairs and/or adjustments be done by your local Blodgett service agency and not by the owner/operator. Blodgett cannot as-
sume responsibility for damage as a result of servicing done by unqualified personnel.
WARNING!!
Always disconnect the power supply before cleaning or servicing the oven.
PLEASE!!
Write down EXACTLY any error message displayed on the operator control display. Report all
error messages.