Specifications

Installation
14
Oven Assembly
CONVEYOR BELT TENSIONER
NOTE: Each tensioner installs between the idle
end of the conveyor (the side opposite the
drive) and the bracket under each convey-
or support angle.
1. The belt tensioner contains a spring to a dj ust
the length. Compress the spring to shorten
the length of t he belt tensioner.
2. Insert the pin on the end of the tensioner into
the hole in the bracket under each conveyor
support angle.
3. Expand the tensioner to engage the pin lo-
cated on the conveyor rack.
Belt
Tensioner
Figure 12
CRUMB PANS
1. Slidethedrivesidecrumbpanunderthecon-
veyor rack from the front. The notch in the
crumb pan must line up with the drive shaft.
2. When the notch is lined up with the drive shaft,
push the crumb pan into the cooking chamber.
Hook the end of the crumb pan over the end of
theconveyorrack.
3. Slide the idle side crumb pan under the end of
theconveyorrack.
4. Slide the product stop over the end of the idle
side crumb pan.
Drive Side
Crumb Pan
Idle Side
Crumb Pan
Product
Stop
Figure 13