Specifications

Installation
12
Oven Assembly
CONVEYOR BELT
NOTE: Conveyor belt is shipped installed on
some units.
NOTE: The following directio n s are writt en for left to
right trave l. For right to left trave l, th re ad th e
belt fro m th e le ft side of th e oven . The t wo
ends will meet on the right side of the oven.
Direction of
Travel
Belt Top
Figure 8
1. Thread the conveyor belt from the right side of
the oven. The conveyor belt has loops on both
ends. The loops must travel backwards on the
conveyor rack to prevent belt damage. See
Figure 9 for proper belt orientation.
Push the belt through the conveyor rack
threading in between the top and bottom
guide rods. Stop when there is approximately
12” (31 cm) of belt hanging out on the left side.
2. Thread the belt around the sprockets on the
left conveyor rack.
3. Take the remainder of the belt, loo p it around the
sprockets o n the right convey or rack.
4. Push the remainder of the belt through the
oven cavity on top of the conveyor racks.
5. Each end of the belt should meet approximatel y
6” (15 cm) past the end of the left conveyo r rack.
Figure 9