Specifications

Installation
10
Oven Assembly
CONVEYOR BELT DIRECTION
Convey or travel is factory set for either left to right or
right to left belt operation as ordered. If the opposi te
directio n is required, the polari ty of the drive motor
must be reversed as follows and the conveyor belt
must be removed, reversed and reinstal l ed or the
belt wil l be damaged. Refer to page 12 for belt instal-
lation instructions.
To reverse pol arity:
1. WIth the oven cold, DISCONNECT THE POW-
ER CORD TO THE OVEN. Unscrew the electri-
cal box access cover.
2. Flip the dipswitch marked DIR1 on SW4 (switch
4) o n the interface board. See Fi gure 6.
NOTE: The inte rfa c e board is locate d on the
upper rear surface of the electrical box.
Heat
Relay
Blower 1
Relay
Circulation Blowers’
Pressure Switch
Switch 4
(See View A)
View A
ENB 2
DIR 2
ENB 1
DIR 1
SW4
Blower 2
Relay
Interface Board
Figure 6