Repair manual

MT3855
5
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
20
19
FIGURE 3
CLEANING AND MAINTENANCE
CAUTION!
The oven and the ventilation system get
hot during operation. Allow the oven/
ventilation system assembly to cool so
as to avoid possible injury.
EVERY MONTH
1. Remove the End Enclosures (items 15-18) by
lifting them up and pulling them away from the
oven.
2. Remove the Filters (items 10 and 11) by lifting
them up and then swinging the bottom out and
down.
3. Remove the Filter Trough Receptacles (item
9).
4. Clean the parts by running them through a
dishwasher or wash them by hand with hot,
soapy water. Do not use scouring pads
(plastic or metal) on the exterior surfaces.
They will scratch and mar the exterior finish.
Rinse the panels in warm water and dry them.
5. Reinstall the Filter Trough/Receptacles, Filters
and End Enclosures.
EVERY THREE MONTHS
1. Remove the End Enclosures (items 15-18) by
lifting them up and pulling them away from the
oven.
2. Remove the Filters (items 10 and 11) by lifting
them up and then swinging the bottom out and
down.
3. Remove the Filter Trough Receptacles (item
9).
4. Lift off the Cooling Fan Exhaust Enclosure
(item 14).
5. Remove the Vertical Exhaust Manifolds (items
12 and 13) by removing the thumb screws.
6. Clean the parts by running them through a
dishwasher or wash them by hand with hot,
soapy water. Do not use scouring pads
(plastic or metal) on the exterior surfaces.
They will scratch and mar the exterior finish.