Repair manual

MT3855
3
COMPUTER CONTROL CONFIGURATION
INITIATING ACCESS MODE
The Cooking Computer provides a special Access
Mode for setting and displaying certain computer
special functions. To initiate the Access Mode
place the control in the OFF state, (OFF is shown
in the display when power is first applied to the
control). Press the following sequence of keys to
set the control to Access Mode: CLEAR 1 2 3 4 5
6 ENTER. The display will show ACCESS.
CONFIGURATION
When the controller is in the ACCESS" mode,
press the following buttons: CLEAR 1 1 1 ENTER.
With the exception of the positive and negative offĆ
sets, to be addressed later, all display data should
correspond to the entries in the chart below. If the
data does not match the chart, it should be
changed accordingly. When the correct data is disĆ
played press the PROG/ENTER key, the display
will cycle on to the next screen. If a step is missed,
press the CLEAR button to backup.
DISPLAY ACTION
TAKEN
DISPLAY ACTION TAKEN
F/CMODE? Press
PROG
ENTER
T  F(C)
Press again or hit any number and
it will change.
PROG
ENTER
POS OFFSET? Press
PROG
ENTER
0(0) Press
PROG
ENTER
NEG OFFSET? Press
PROG
ENTER
0(0) Press
PROG
ENTER
MAXĆT ENTRY? Press
PROG
ENTER
600(315) Press or change then
press again.
PROG
ENTER
MAXĆT LIMIT? Press
PROG
ENTER
625(330) Press
PROG
ENTER
READY BAND? Press
PROG
ENTER
10 Press
PROG
ENTER
MINĆHT ON? Press
PROG
ENTER
60 Press
PROG
ENTER
DISPLAY INTEG? Press
PROG
ENTER
30 Press
PROG
ENTER
TĆCTRL INTEG? Press
PROG
ENTER
10 Press
PROG
ENTER
TABLE 1