Repair manual

MT3855
1
OVEN ASSEMBLY PROCEDURES
RETURN AIR DIVERTERS
For units manufactured prior to 11/14/95
1. Slide the return air diverters into the oven and
clip to the lower rear of the baking cavity. The
edge of the diverter should be 3" (7.6 cm) from
the outside edge of the oven cavity.
IMPORTANT:
Note Orientation Of Return Air Diverters!
FIGURE 1
For units manufactured after 11/14/95
1. Lift the front end of the diverter and slide the
clips up and behind the rear oven wall.
2. Lower the front end and slide the diverter into
place. Be careful to install the diverters in the
correct order as shown in FIGURE 2. Make
sure that the edges of the end diverters line up
with the cutout in the rear oven wall.
Diverter
M7273
Inner Diverter M7373
Diverter
M7374
End Plug End Plug
TOP VIEW OF OVEN
FIGURE 2
AIR NOZZLES
1. Install the nozzles from the center of the oven
to the ends. The bottom of the nozzle must fit
into the slot of the nozzle support located at the
front of the oven.
2. Secure the nozzle holdĆdown strip across the
inside front of the oven using the existing
screws attached to the oven wall.
End
Plug
End
Plug
M7106
M7105
TOP VIEW OF OVEN
Nozzle M7105 is
identified by one
hole in flange at
open end
Nozzle M7106 is
identified by two
holes in flange at
open end
FIGURE 3