Specifications

Installation
8
Oven Assembly
CONVEYOR BELT
The belt has loops on both ends. These loops
must ride backwa rd on the conveyor s upport. Also
note that the belt has a top and bottom. Refer to
Figure 7.
Belt Top
Direction of
Conveyor Travel
Figure 7
NOTE: Unless specified otherwise, conveyor trav-
el is factory set for left to right operation
when facing the front of the oven. If a direc-
tion change is required, the polarity of the
drive motor must be reversed. To reverse
the motor polarity, interchange the black
and white motor leads at the D.C. control-
ler located in the control panel. In addition,
the conveyor belt must be installed from
theleftsideoftheoven.
1. Thread wire belt starting from the right hand
side ofthe oven, lower levelfirst. Unrollthe belt
asshowninFigure8,otherwisethebeltwillbe
upside down. Leave about one foot hanging
out on the left side
NOTE: If belt travel is from left to right, thread
wire belt starting from left side of oven.
2. Take the remainder of the belt, loop it around
the right shaft. Push through on the upper lev-
el.
3. The two ends of the belt should be approxi-
mately 6 -9 inches past the left shaft on the up-
per level of the belt support. Right shaft if right
to left travel is required.
Figure 8
Figure 9