Specifications

Installation

Oven Assembly

CONVEYOR BELT

Be sure to install the belt from left to right. The con -

veyor belt has loops on both sides. The loops must

travel backwards on the conveyor support. See

Figure 8.

Belt Top

Direction of

Conveyor Travel

Figure 8

Unless specified otherwise, conveyor travel is fac-

tory set for left to right operation when facing the

front of the oven. To change direction:

Reverse the polarity of the drive motor. Inter-

change the black and white motor leads at the

D .C. controller located in the control panel.

Install the conveyor belt from the left side of the

oven.

To thread the conveyor belt

1. Start from t he right hand side of the oven, low-

erlevelfirst.Unrollthebeltasshownin

Figure 9, otherwise the belt will be upside

down. Leave about one foot hanging out on

the left side

NOTE: If belt travel is from left to right, start

fromtheleftsideoftheoven.

2. Take the remainder of the belt, loop it around

the right shaft. Push through on the upper lev-

el.

3. The two ends of the belt should be approxi-

mately 6 -9 inches past the left shaft on the up-

per level of the belt support. Right shaft if right

to left travel is required.

Figure 9

Figure 10