Repair manual

INTRODUCTION
1-2
Installations outside the U.S.
MT2136G ovens require a 15 amp, 50HZ, 1F,
220Ć240VAC, 3 wire service consisting of L1, neuĆ
tral and ground. See FIGURE 2. Use 90C wire and
size to National Electric or local codes.
MT2136E ovens are available in either 1F or 3F opĆ
tions. Single phase units require a 15 amp, 50 HZ,
240VAC 3 wire service consisting of L1, L2 and
ground. Three phase units require a 15 amp, 50
HZ, 220Ć240 VAC 4 wire service consisting of L1,
L2, L3 and ground. See FIGURE 1. Use 90C wire
and size to National Electric or local codes.
CE approved installations
The MT2136G requires a 15 amp 50Hz, 1F, 230
VAC, 3 wire service consisting of L1, neutral and
ground. Connect exhaust fan connector 1 and 2.
See FIGURE 2. Use 90C wire and size according
to local codes.
NOTE: If the phase and neutral are switched the
control locks out.
The MT2136E requires a 15 amp, 50Hz, 3F, 230
VAC, 5 wire service consisting of L1, L2, L3, neutral
and ground. See FIGURE 2. Use 90C wire and
size according to local codes.
240
s
Connector
1
2
L3
L2
L1
N
Fan
N
L
Blodgett
Connector
2Ć4Ć92
A2
A1
2
1
Relay A
2
1
Air Pressure Regulator
Burner Control Solenoid
MT2136G CE Approved Installations
L1
N
230
OvenSupply
MT2136G - Export Installations
L1
N
220Ć240
OvenSupply
MT2136E - Single Phase Export Installations
MT2136E - Three Phase Export Installations
L1
L2
L3
230
OvenSupply
N
400
400
400
MT2136E - CE Approved Installations
L1
240
OvenSupply
L2
L1
L2
L3
OvenSupply
FIGURE 2