Owner`s manual

PLC Control Startup

Belt Speed Calibration

6. The display reads:

SELECT MOTOR RATIO

Use the arrow keys to scroll to the correct mo-

tor ratio. Press the ENTER/RESET key to se-

lect the correct motor ratio value.

7. The display reads:

TIME CAL DONE?

U P --- E X I T D O W N --- C O N T

Press the up arrow key to exit the Belt Speed

Cali bratio n Mode and return to the service level

menu, or press the down arrow key to return to

step 2 of the belt speed cali bratio n pro cedure.

To Exit Calibration Mode:

1. Press and hold the UP ARROW and ENTER/

RESET keys simultaneously for approximately

three seconds.

Model

Oven Length Shaft Teeth Motor Teeth Belt Radius Motor Ratio

SG2136 36” 30 30 0.8850 18

SG3240 40” 15 15 0.8850 18