Repair manual

ASSEMBLY

2-2

4. Install the inner and outer master links as

shown in FIGURE 3.

Master

Link

Direction of

Travel

FIGURE 3

Unless otherwise specified, the conveyor travel is

factory set for leftĆtoĆright operation when facing

the drop down door. If a direction change is reĆ

quired, the polarity of the drive motor must be reĆ

versed. To change the polarity of the drive motor,

disconnect the oven from the power source and inĆ

terchange the black and white motor leads at the

D.C. Controller Board located within the control

box. If the polarity of the motor is changed to

rightĆtoĆleft belt travel, the conveyor belt must

be installed from the left side of the oven inĆ

stead of the right side.

NOTE: Reconfigure the air plates whenever the

conveyor belt direction of travel is

changed. See FIGURE 4.

Burner Side

Front Of Oven

7 holes

Air Hole

BlockĆoff

Slots

Closed

Slots

Closed

Burner Side

Front Of Oven

7 holes

Air Hole

BlockĆoff

Slots

Closed

Slots

Closed

DIRECTION OF TRAVEL

FIGURE 4