Specifications

Installation
8
Oven Assembly
CONVEYOR
1. Slide the conveyor assembly through the left
hand tunnel opening until the sprocket is in-
sidethecontrolbox.SeeFigure6.
2. Install the drive belt on the motor and then
around the pulley on the conveyor assembly.
See Figure 7. Pull the conveyor assembly
back to tighten the belt.
Figure 6
Figure 7
Unless specified otherwise, conveyor travel is fac-
tory set for left to right operation when facing the
front of t he oven. To reverse the direction of the
drive motor (if necessary), exchange A 1 and A2.
WARNING!!
Disconnect the power supply before re-
versing the drive motor.
CRUMB PANS
1. Install the crumb pans on both ends of the
conveyor.
Figure 8