Specifications
Operation
26
Blodgett IQ2T Control
PROGRAMMING MULTIPLE STAGE RECIPES
Entering the Programming Mode:
1. Press and hold the PROG KEY (10). The top
display reads CodE.
2. Use the product keys to enter the program-
ming access code: 3 1 2 4. Press the ENTER
KEY (14). The top display reads Prod.
3. Presst he desired product key followed bythe
ENTER KEY (14).
Programming the Cook Time:
NOTE: When multiple stage cooking is being
used, the countdown time displayed dur-
ing cooking is the sum of all stages.
1. The t op display reads P1:__. The bottom dis-
playgivesthe current programmed cooktime
for stage 1 in minutes:seconds. Press the
TOGGLE/CLEAR KEY (11). Use the product
keystoenterthenewcooktime.PresstheEN-
TER KEY (14) to save the new cook time.
2. The top display reads P2:__. The control is
asking for the cook time for the second stage
ofthisrecipe.RepeatStep1foreachaddition-
al stage.
3. When the cook times for all s tages are pro-
grammed, press the TOGGLE/CLEAR KEY
(11) to clear the bottom display.
NOTE: This tells the controller that there are
no more stages for this recipe. Once
the number of stages has been estab-
lished the control will only allow en-
tries for these stages on all further pa-
rameters for this product.
4. Press the ENTERK EY (14)again. The display
readsP1:. Thebottomdisplayshows thecook
time.
5. Press the SCAN KEY (15) toadvance the pro-
gramming mode to cook temperature.
Programming the Cook Temperature:
1. The top display reads Ct --- 1. The bottom dis -
play gives the current cook temperature for
stage 1of thisrecipe. Use the product keys to
enter the desired cook temperature.
2. Press the ENTER KEY (14) to save the new
cook temperature forstage 1. The top display
reads Ct --- 2.
NOTE: Repeat Steps 1---2 to program the
cook temperature for additional
stages. When the cook temperature
for the final stage has been entered
the top display reads Ct---1.
3. Press the SCAN KEY (15) toadvance the pro-
gramming mode to fan speed
Programming the Fan Speed:
1. The top display reads SPd1. The bottom dis-
play gives the current fan speed. Press the
TOGGLE/CLEAR KEY (11). The bottom dis -
play toggles betw een HI and Lo.
2. Press the SCAN KEY (15) toadvance the pro-
gramming mode to the fan cycle time.