Hydrovection Owners Manual

ManualsBrandsBlodgett ManualsCommercial Convection OvensHV-100E BASE HydroVection Series Energy Star Electric Oven with Steam and Convection Heating, Compact 38" Footprint, Cavity Drain and Stainless Steel Construction: Single Base Oven

Operation

MenuSelect™ Control

USING THE USB PORT

1. With the power on, remove the cover of the USB port

(20) and insert the USB drive.

2. Press the MAINTENANCE KEY (15).

3. Turn the dial to highlight MANAGER PROGRAM.

Press the center of the dial to select.

4. Turn the dial to highlight either COPY RECIPE FROM

USB or COPY RECIPE TO USB, then press the cen-

ter of the dial to select.

5. When the transfer is complete, press any key to re-

turn to the menu.

6. Turn the dial to highlight EXIT. Press the center of

the dial to select. The display returns to the previous

menu.

7. Turn the dial to highlight EXIT. Press the center of the

dial to select.

MANAGER PROGRAMMING

Entering the Manager Program Mode

1. Press the MAINTENANCE KEY (15). If the control

is password protected, the display reads ENTER

CODE. Use the alpha/numeric keypad to enter the

manager passcode 6647, then press the center of the

dial to enter the program mode.

2. Turn the dial to highlight OVEN SETUP. Press the

center of the dial to select the product.

Programming Auto Start

NOTE: The Auto Start function enables the oven to turn

on at a programmed time of day and preheat to

a programmed temperature.

1. Turn the dial to highlight AUTO START. Press the

center of the dial to select.

2. Turn the dial to select either ON or OFF. Press the

center of the dial to select.

If ON is selected, the display reads AUTO START 24

HOUR TIME 00:00. Turn the dial to enter the time you

would like the oven to begin preheating. Press the

center of the dial to select.

The display reads AUTO START TEMP XXX. Turn

the dial to enter the desired preheat temperature.

Press the center of the dial to select.

Programming Oven Setup

These menus allow the manager to set up basic oven

functions

1. Turn the dial to highlight OVEN SETUP. Press the

center of the dial to select.

2. Turn the dial to highlight MANAGER PROGRAM.

Press the center of the dial to select.

3. Turn the dial to highlight the oven function you wish to

change. Press the center of the dial to select. Choose

from the following functions:

Recipe Password - Select YES or NO to enable

password protection on recipe programming. If YES

is selected the passcode 3124 must be entered to

change recipe programming.

Temp Unit - Select either degrees F or C.

Cool Down Temp - Select the set temperature for

the oven to achieve in Cool Down mode

Temp Disp Rate - Set the rate, in seconds, at which

the display switches between actual and setpoint

temperature

Input Rsp Time - Set the length of time allowed to in-

put each variable when programming recipes before

control automatically exits out

Setback Time - When not used for a period of time,

the oven temperature will automatically reduce to

conserve energy. This variable sets the length of time

the oven remains at the idle temperature before be-

ing lowered.

Ready Beep - Select either ON or OFF. This is the au-

dible alarm that sounds when the oven has reached

the set temperature.

Cook Cool Fan - Select either YES or NO. This func-

tion allows the control to display OPEN OVEN DOOR

when you are attempting to lower the set temperature

of the oven.

Restore Manual - Select either YES or NO. This vari-

able enables the oven to remember the last settings

used for manual cooking.

4. After editing a function, press the center of the dial

to save.

5. When all desired functions have been edited, turn the

dial to highlight EXIT. Press the center of the dial to

exit the manager programming mode.