Hydrovection Owners Manual

Installation

Plumbing Connections

WATER CONNECTION

NOTE: Must use COLD WATER ONLY.

Connect the appliance to quality water via a pressure

hose with 3/4” GHT (19mm) couplings. See Figure 6 for

connections. A shut off valve is to be provided adjacent to

the oven.

WARNING!!

Operating the appliance without a water pres-

sure regulator installed will invalidate your

warranty.

This product must be installed by a licensed Plumber or

Gas Fitter when installed within the Commonwealth of

Massachusetts.

DRAIN CONNECTION

The drain should be run to an open oor drain avoiding

exible hose that could sag and allow trapped water to

accumulate. The customer must supply the piping from

the oven to the drain.

Specic water/drain connection for City of Los Ange-

les

1. Each drain line from the appliance shall be routed

without dips or sags to terminate above the ood level

rim of an approved indirect waste receptor.

2. The appliance shall be installed in accordance with

the manufacturer’s printed instructions and the LAPC

and LAMC, 1999 editions.

3. A backow protection device may be required by lo-

cal codes. If so, install on the potable water system

directly ahead of the appliance. The backow protec-

tion device shall be any of the following: an approved

pressure type vacuum breaker installed at least 12”

above the highest point of use, a double check valve

backow preventer or a reduced pressure principal

backow preventer.

Figure 6

HV-100E & HVH-100E

HV-100G & HVH-100G

A = Electrical Connection

B = Gas Connection

C = Water Connection

Filtered Water highly recommended

D = Drain Connection