Specifications
Operation
22
Solid State Digital Control with Core Temperature Probe
Low Temperature Roast and Hold with the Core
Temperature Probe:
Use to roast product at your convenience and hold
it for serving at a later time. This produces a quality
product with a higher yield than traditional roasting.
1. Turn the SELECTOR SWITCH (1) to low fan.
NOTE: High fan is not recommended for low
temperature roasting.
2. Preheat the oven.
3. Insert the core probe into the product. Be sure
to insert the probe to the center of the product.
4. Press TEMP (7) key. Rotate the DIAL (6) to enĆ
ter the cook temperature.
5. Press CORE PROBE KEY (10). Rotate the dial
(6) to enter the desired final probe temperature.
6. Press the Cook & HOLD KEY (11).
7. Load the product and plug the probe into the
connector in the upper right corner of the
oven, just inside the door.
8. Close the door. It is not necessary to press the
START KEY (12). The low temperature cookĆ
ing process starts automatically after the
probe is connected in step 7.
NOTE: The display gives the actual core
probe temperature and the CORE ACĆ
TUAL TEMP lamp (4) lights.
9. The control will lower the cavity temperature
as the core probe actual temperature inĆ
creases. When the core probe actual temperĆ
ature is close to the core probe set temperaĆ
ture, the control automatically turns the oven
set temperature down to minimize overshoot.
10. The following adjustments can be made durĆ
ing the cook cycle:
a. Press the CORE PROBE KEY (10) to disĆ
play the core probe set temperature. To
change the core set temperature turn the
DIAL (6) to select the new temperature.
Press the CORE PROBE KEY (10) to return
the display to core temperature.
b. Press the TEMP KEY (7) the display gives
the actual cavity temperature and the
CAVITY ACTUAL TEMP lamp (5) is lit.
When the temp key is released the display
gives the cavity set temperature and the
LED on the temp key is lit. To change the
cavity set temperature turn the DIAL (6) to
select the new temperature. Press the
CORE PROBE KEY (10) to return the disĆ
play to core temperature.
11. When the product has reached the core probe
set temperature the buzzer sounds three
times. The oven cavity holds at the core probe
temperature.
When ready to serve, unplug the core probe
and remove the product.