Specifications

Operation
36
IQ Control
2ND LEVEL PROGRAMMING
Entering the programming mode
1. Press the PROG KEY (9). The top display
reads CodE.
2. Use the product keys to enter the programĆ
ming access code: 4 5 1 2. Press the ENTER
KEY (13). The top display reads SYS.
Programming hold
Hold allows product to be kept warm in the oven
at a programmed time and temperature. There are
two hold modes available, auto and manual. If
auto hold is enabled the control will automatically
place the oven into the hold mode at the end of
each cooking cycle. If manual hold is enabled the
unit can be placed into the hold mode at any time.
1. Press the SCAN KEY (14). The top display
reads HoLd. Press the TOGGLE/CLEAR KEY
(10) to toggle between YES and no. Press the
SCAN KEY (14).
If no is chosen:
a.) The controller advances to programming
the setback mode.
If yes is chosen:
a.) The top display reads AUto. Press the
TOGGLE/CLEAR KEY (10) to toggle beĆ
tween YES and no. Press the SCAN KEY
(14) to enter the desired hold mode.
b.) The top display reads HoLd. The bottom
display gives the current hold time. Press
the TOGGLE/CLEAR KEY (10). Use the
product keys to enter a hold time from 0
to 9 hours. Press the SCAN KEY (14) to
enter the new hold time.
c.) The top display reads HoLd. The bottom
display gives the current hold temperaĆ
ture. Press the TOGGLE/CLEAR KEY (10).
Use the product keys to enter a hold temĆ
perature from 140_F-210_F. Press the
SCAN KEY (14) to enter the new hold temĆ
perature.
d.) The top display reads FAn. The bottom
display gives the current fan mode. To
change the fan mode press the TOGGLE/
CLEAR KEY (10). The bottom display
toggles between Hi and Lo. Press the
SCAN KEY (14) to enter the new fan mode
and continue with programming the setĆ
back mode.
Programming the setback mode
The setback mode operates as a power saving
feature. After a period of nonĆuse (the setback
time) the oven temperature automatically deĆ
creases to the setback temperature. The oven will
maintain this temperature until a product key is
pressed.
1. The top display reads SEtb. The bottom disĆ
play gives the setback mode. To change the
setback press the TOGGLE/CLEAR KEY (10).
The bottom display toggles between YES and
no. Press the SCAN KEY (14).
If no is chosen:
a.) The controller advances to programming
the temperature mode.
If yes is chosen:
a.) The bottom display gives the current setĆ
back time. Press the TOGGLE/CLEAR
KEY (10). Use the product keys to the enĆ
ter the desired setback time. Press the
SCAN KEY (14) to enter the new setback
time.
NOTE: The minimum setback time is 20:00.
The maximum setback time is 59:59.
b.) The bottom display gives the current setĆ
back temperature. Press the TOGGLE/
CLEAR KEY (10). Use the product keys to
the enter a setback temperature from
140_F-300_F. Press the SCAN KEY (14)
to enter the new setback and continue
with programming the temperature
mode.
Programming the temperature mode (_F or _C)
1. The top display reads dEg. The bottom disĆ
play gives the units. To change the units press
the TOGGLE/CLEAR KEY (10). The bottom
display toggles between F and C.
2. Press the SCAN KEY (14) to enter the new
temperature units and continue programming
the oven size.