Specifications

Operation
33
IQ Control
PROGRAMMING MULTIPLE STAGE RECIPES
NOTE: Refer to the KFC Standards Library for acĆ
tual recipes.
Entering the Programming Mode:
1. Press the PROG KEY (9). The top display
reads CodE.
2. Use the product keys to enter the programĆ
ming access code: 3 1 2 4. Press the ENTER
KEY (13). The top display reads Prod.
3. Press the desired product key followed by the
ENTER KEY (13).
Programming the Cook Time:
NOTE: If any stage of the product has a cook
time of greater than 59:59 the top disĆ
play reads Px-- for the product,
stage and hours. The bottom display
counts down the cook time in minĆ
utes:seconds.
1. The top display reads P1:__. The bottom disĆ
play gives the current programmed cook time
for stage 1 in minutes:seconds. Press the
TOGGLE/CLEAR KEY (10). Use the product
keys to enter the new cook time. Press the ENĆ
TER KEY (13) to save the new cook time.
2. The top display reads P2:__. The control is
asking for the cook time for the second stage
of this recipe. Repeat Step 1 for each additionĆ
al stage.
3. When the cook times for all stages are proĆ
grammed, press the TOGGLE/CLEAR KEY
(10) to clear the bottom display.
NOTE: This tells the controller that there are
no more stages for this recipe. Once
the number of stages has been estabĆ
lished the control will only allow enĆ
tries for these stages on all further paĆ
rameters for this product.
4. Press the ENTER KEY (13) again. The display
reads P1:. The bottom display shows the cook
time.
5. Press the SCAN KEY (14) to advance the proĆ
gramming mode to cook temperature.
Programming the Cook Temperature:
1. The top display reads Ct-1. The bottom disĆ
play gives the current cook temperature for
stage 1 of this recipe. Use the product keys to
enter the desired cook temperature.
2. Press the ENTER KEY (13) to save the new
cook temperature for stage 1. The top display
reads Ct-2.
NOTE: Repeat Steps 1-2 to program the
cook temperature for additional
stages. When the cook temperature
for the final stage has been entered
the top display reads Ct-1.
3. Press the SCAN KEY (14) to advance the proĆ
gramming mode to fan speed
Programming the Fan Speed:
1. The top display reads SPd1. The bottom disĆ
play gives the current fan speed for stage 1.
Press the TOGGLE/CLEAR KEY (10). The botĆ
tom display toggles between HI and Lo.
2. Press the ENTER KEY (13) to save the new fan
speed for stage 1. The top display reads
SPd2.
NOTE: Repeat Steps 1-2 to program the fan
speed for additional stages. When the
fan speed for the final stage has been
entered the top display reads SPd1.
3. Press the SCAN KEY (14) to advance the proĆ
gramming mode to the fan cycle time.