User manual

Installation

Electrical Connections

Before making any electrical connections to these

units, check that the power supply is a dequate for

the voltage, a mperage, and phase requirements

stated on the rating name plate mounted on the

right side of the unit.

Wiring diagrams are located on the inside of the

removablesidepanel.

NOTE: DISCONNECT THE POWER SUPPLY TO

THE UNIT BEFORE SERVICING!

U.S. and Canadian installation

All units, w hen installed, must be electrically

grounded in accordance with local codes or in the

absence of local codes, with the National Electrical

Code, ANSI/NFPA 70 ---Latest Edition and/or Cana-

dian Electrical Code CSA C22.1 as applicable.

General Export Installations

Installation must conform with Local and National

installation standards. Local installation codes

and/or requirements may vary. If you have any

questions regarding the proper installation and/or

operation of your unit, please contact your local

distributor. If you do not have a local distributor,

please call Blodgett Combi at 0011-802 -860-3700.

WARNING!!

Improper electrical installation will invali-

date your warranty.

Gas Models

U.S. and Canadian Installations

A power cord (115V or 230V) is supplied with a

plug attached. Plug the power cord into the de-

sired receptacle.

WARNING!!

If the supply cord is damaged, it must be

replaced by a special cord or assembly

available from the manufacturer or its ser-

vice agent.