Specifications

Maintenance
23
Spray Bottle Operating Procedure
WARNING!!
Alway s disconnect the power supply be-
fore servicing or cleaning the unit.
1. Unscrewthesprayerheada ndfillthecontain-
ertotheMAXmark. Screwtheheadassembly
on firmly to ensure an airtight seal. The liquid
mustbecleanandfree fromforeignmatter.Do
not overfill - space must be left for compress -
ing air.
2. Tobuilduppressure,pumpapproximately20
fullstrokeswhenthecontainerisfilled withliq-
uid. The higher the pressure, the finer the
spray. If the container is only partially filled,
then more pumping is required to compress
the additional air space.
3. Tospray, depressthe triggerwith yourthumb.
4. After a period of spraying, the pressure will
drop. Restore the pressure by operating the
air pump.
5. Release pressure after use by inverting the
spray head and depressing the trigger or by
slow ly unscrewing the spray headassembly
which will allow airto escapefrom around the
filling aperture.
6. Afteruse,rinsethespraybottlewithcleanwa -
terandcheckthatthe holeinthenozzleisper-
fectly clean and clear. Warm water (not hot)
used with a household detergent is a useful
cleaning agent for this purpose.
NOTE: Further information can be found in the in-
struction leaflet supplied with your spray
bottle.
WARNING!!
Protective clothing and eyewear should
be worn while using cleaning agents.
MAX
Spray
Head
Pressure Pump
Spray Trigger
Pressure
Vessel
Pump
Clean the pump 2 or 3 times per week with warm water
Figure 14