Specifications

Maintenance
34
Deliming
NOTE: The following procedures apply to models
BC14E and BC14G only.
WARNING!!
Deliming solutions are hazardous and
can cause burns to the skin and eyes.
Wear protective clothing and eyewear
when decalcifying your appliance.
Deliming of the steam generator is the single most
important preventative maintenance task. Lime
will build up inside the steam generator, reducing
efficiency and causing damage to the level control
system.
WARNING!!
Problems caused by insufficient deliming
are not covered by the warranty.
This oven comes equipped with a Delime lamp to
indicate when the steam generator needs to be
delimed. The Delime lamp will flash when the
steam generator has been run for the preset interĆ
val. The flashing Delime lamp does not impede the
operation of the oven, as you can use the oven
normally when the lap is flashing. You may choose
the best time to start the deliming process.
NOTE: To further prevent buildup of scale, this
oven will automatically drain the steam
generator after 5 hours of being in the off
mode.
WARNING!!
The oven must be placed in cool down
mode for 1 minute with the door open
prior to starting the deliming process.
Once the process has been started, the
oven cannot be used until the process is
complete. The total process time is
approximately 45 minutes.