Repair manual

BC14G
1 --- 3
OVEN LOCATION
Certain minimum clearances must be maintained
between the oven and any combustible or non -
combustible construction. See the following table.
The following clearances are recommended for
servicing.
D Oven body sides --- 12” (30cm)
D Oven body back --- 12” (30cm)
NOTE: On gas models, routine servicing can usu-
ally be accomplished within the limited
movement provided by the gas hose re -
straint. If the oven needs to be moved fur-
ther from the wall, the gas must first be
turned off and disconnected from the oven
before removing the restraint. Reconnect
the restraint after the oven has been re-
turned to its normal position.
Left Side Heat Shield
Heat sources should not be near the air vents lo-
cated on the left hand side of the gas appliance.
Consult the factory for optional protective side heat
shield.
BC14G P/N R9527
Oven
M
d
l
MINIMUM REQUIRED
CLEARANCES
Model
Right Side Left Side Back
BC14G 1”
(25.4mm)
6”
(152.4mm)
6”
(152.4mm)
TABLE 7