Repair manual

INSTALLATION
9 --- 6
Adju st for small gap
FIGURE 6
Checking Doo r Adjustment
NOTE: When the door is adjusted properly, you
should be able to close a dollar bill be-
tween the door and gasket on all four sides
of the door and s till be able to pull it out. If
you cannot, the door is too tight, and must
be readjusted.
1. Check the closing of the door in the steam
mode.
2. Next check the closing of the door when the
oven is heated to 374_F.
3. The door should close easily in both condi-
tions. If it does not, the door is too tight and
must be readjusted.
FINE TUNING A DOOR GASKET
Use the following procedure if the door shuts well
in both hot air and steam, but, you still have a little
steam leaking from the door gask et:
1. Makeanotewherethesteamisleaking.
2. Take a tube of silicone and lay a bead out on
aflatsurface.Letitdry.
3. Tack the bead behind t he door gask et with a
couple of dabs of silicone. This pushes the
gasket out enough to seal the steam leak and
does not over t ighten the door.
OR:
1. If you look behind the gasket, it is held in place
with a metal bar with screws. Change the
screws behind the gasket where it is leaking to
10/24 round head screws. Use stainless
screws and put NEVER SEAZE on the threads
so they won’t bind.