Repair manual

BC14G AND BC14E
5 --- 1
TROUBLESHOOTING SEQUENCE
ALW AYS troubleshoot a Synergy oven in the fol-
lowing sequence;
1. Cool Down
2. Hot Air
3. Steam
4. Combi
By foll owing this sequence you bring in components
graduall y. DO NOT proceed to the next mode of op-
eration until you have verified Cool Down works first.
If possible, contact the customer before visiting the
sight and have them check operation of the Synergy
oven in each mode of operatio n. Suggested ques-
tions are li sted with each failure mode. Have a sche-
matic in hand when askin g questio ns. By asking the
questions i n the proper sequence you are slowly
troubleshooting the circuit.
COOL DOWN MODE
NO operation with the mode switch in the COOL
DOWN mode.
1. Is the oven plugged in?
2. Is the deliming switch on the left hand side of
theoveninthe“ON”position?
3. Push the fan speed control switch. Does the
convection motor come on?
HOT AIR MODE
NO operation with the mode switch in the HOT
AIR mode.
1. Does the green power on light on the top right
corner of the control panel come “ON” or light
up?
2. Turn the t imer up to 10 minutes and then
manually turn the timer down to the “zero”
position. Does the timer alarm “BUZZ” or
sound?
3. If you turn the thermostat knob up, does the
red thermostat light to the right of the thermo-
stat come “ON” or light up?
(Gas Ovens Only)
4. Is the gas turned “ON” in the rear of the oven
and turned “ON” in the slide panel in the lower
left on the front of the oven?
5. Turn the mode switch to the “OFF” position
andthenturnitbackontothe“HOTAIR”
mode. Can you hear t he oven “sparking” or
“tick-tick-tick”?