Repair manual

PARTS REPLACEMENT
6-2
ELEMENT
1. Disconnect power from main power supply.
2. Remove right hand side panel (left hand on a
CTBR )
3. Remove the element terminal cover found
above motor and disconnect wires.
4. Remove element plate and insulation spacer.
5. Remove racks and rack support from oven.
6. Remove baffle by placing hand under back
end and rotating up and out.
7. Remove the eight screws holding the element
assembly to the side wall of the oven.
8. Install new elements by reversing the above
mentioned procedure.
MOTOR
1. Shut off main power supply.
2. Remove Rack and rack supports.
3. Remove baffle by placing hand under back
end and rotating up and out.
4. Remove blower wheel, pay particular attention
to the style of blower wheel you have some of
the wheels have built on wheel pullers.
5. Remove right hand side panel ( left hand panel
if the oven is a CTBR).
6. Disconnect wiring from motor.
7. Remove four bolts holding motor to motor
mount.
8. Install new motor by reversing the above menĆ
tioned procedure.