Repair manual

CTB and CTBR
6-1
DOOR
1. Open door and locate hinge pin bolts.
2. Loosen top bolt of top hinge pin and remove
the bottom bolt of top hinge pin.
3. Using the loosened bolt, push the hinge pin
down into the door.
4. Lift the door out and up.
5. To reinstall reverse the above mentioned proĆ
cedure.
DOOR INTERLOCK SWITCH
1. Shut off main power supply.
2. Open control compartment panel.
3. Remove wires from door interlock switch.
4. Remove retaining screws.
5. Install new switch by reversing the above menĆ
tioned procedure.
WINDOW ASSEMBLY
1. Remove the door as described. Place the door
on a flat surface with the front facing up.
2. Remove the outer door skin. Turn the door
onto its back.
3. Use the window insertion tool to pry up the corĆ
ners of the window assembly in the following
order:
A.) Bottom right (farthest from the hinge pin)
B.) Bottom left
C.) Top right
D.) Top left (closest to the hinge pin)
NOTE: The window insertion tool is provided
with the window assembly.
4. Use the window insertion tool to pry up the corĆ
ners of the window assembly.
5. Reverse steps 1-4 to replace.
NOTE: To install the door front start at the corĆ
ner closest to the hinge pin.
Window
Insertion Tool
Hinge Pin
FIGURE 1