Repair manual

ASSEMBLY
1-4
LEGS AND CASTERS
4" (10CM) LEG ATTACHMENT
1. Lay the oven on its side.
2. Screw one leg into each of the corner nuts.
FIGURE 6
CASTER INSTALLATION
NOTE: Casters are not supplied for the 4" (10cm)
legs, 5Ć3/4" (15cm) or 7" (18cm) stands.
NOTE: Install the locking casters on the front of the
oven. Install the nonĆlocking casters on the
back of the oven.
1. Insert the caster into the leg. Secure the caster
to the leg by tightening the locknut.
FIGURE 7
OVEN LEVELING
After assembly, the oven should be leveled and
moved to the operating location.
1. The oven can be leveled by adjusting the feet
or casters located on the bottom of each leg.
ADJUSTMENTS ASSOCIATED WITH INITIAL
INSTALLATION
Each oven, and its component parts, have been
thoroughly tested and inspected prior to shipment.
However, it is often necessary to further test or adĆ
just the oven as part of a normal and proper instalĆ
lation. These adjustments are the responsibility of
the installer, or dealer. Since these adjustments are
not considered defects in material or workmanĆ
ship, they are not covered by the Original EquipĆ
ment Warranty. They include, but are not limited to:
D calibration of the thermostat
D adjustment of the doors
D leveling
D tightening of fasteners.
No installation should be considered complete withĆ
out proper inspection, and if necessary, adjustment
by qualified installation or service personnel.