Specifications

Operation
18
CTBR-AP Control
PROGRAMMING MULTIPLE STAGE RECIPES
NOTE: Refer to the KFC Standards Library for ac-
tual recipes.
Entering the Programming Mode:
1. Press the PROG KEY (9). The top display
reads CodE .
2. Use the product keys to enter the program-
ming access code: 3 1 2 4. Press the ENTER
KEY (13). The top display reads Prod.
3. Press the desired product k ey followed by the
ENTER KEY (13).
Programming the Cook Time:
NOTE: If any stage of the product has a cook
time of greater than 59:59 the top dis-
p l a y r e a d s P x --- --- f o r t h e p r o d u c t ,
stage and hours. The bottom display
counts down the cook time in min-
utes:seconds.
1. The top display reads P1:__. The bottom dis-
play gives the current programmed cook time
for stage 1 in minutes:seconds. Press the
TOGGLE/CLEAR KEY (10). U se the product
keys to enter the new cook time. Press the EN-
TER KEY (13) to save the new cook time.
2. The top display reads P2:__. The control is
asking for the cook time for the second stage
of this recipe. Repeat Step 1 for each addition-
al stage.
3. When the cook times for all stages are pro-
grammed, press t he TOGGLE/CLEAR KEY
(10) to clear the bottom display.
NOTE: This tells the controller that there are
no more stages for this recipe. Once
the number of stages has been estab-
lished the control will only allow en-
tries for these stages on all further pa-
rameters for this product.
4. Press the ENTER K EY (13) again. The display
reads P1:. The bottom display shows the cook
time.
5. Press the SCAN KEY (14) to advance the pro -
gramming mode to cook temperature.
Programming the Cook Temperature:
1. The top display reads C t --- 1 . The bottom dis-
play gives the current cook temperature for
stage 1 of this recipe. Use the product keys to
enter the desired cook temperature.
2. Press t he ENTER KEY (13) to save the new
cook temperature for stage 1. The top display
r e a d s C t --- 2 .
NOTE: Repeat Steps 1 ---2 to program the
cook temperature for additional
stages. When the cook temperature
for the final stage has been entered
the top display reads Ct ---1.
3. Press the SCAN KEY (14) to advance the pro -
gramming mode to fan speed
Programming the Fan Speed:
1. The top display reads SPd1. The bottom dis-
play gives the current fan speed for stage 1.
Press the TOGGLE/CLEAR KEY (10). The bot-
tom display toggles between HI and Lo.
2. Press the ENTER KEY (13) to save the new fan
speed for stage 1. The top display reads
SPd2.
NOTE: Repeat Steps 1 ---2 to program the fan
speed for additional stages. When the
fan speed for the final stage has been
entered the top display reads SPd1.
3. Press the SCAN KEY (14) to advance the pro -
gramming mode to the fan cycle time.