Specifications

Installation
8
Oven Assembly
Stacking two CTBR-AP’s or a CTB biscuit oven
on t op of a CTBR- A P
NOTE: When stacking a CTBR -AP and CTB bis-
cuit oven with the FAST timer, the CTB must
be placed on top.
1. Assemble the low er section to the stand. See
Figure 2.
2. Place the stainless steel crown trim on top of
the lower section.
3. Remove the side control compartment cover
and open the front control panel on the upper
section.
4. With a tool, punch out the k nock-outs in the
oven bottom near each corner of the upper
section.
5. Punch out the knockouts in the top of the low-
er section near the left hand corners.
6. Lay the upper section on its back. Attach the
self adhesive gasket tape to the front and side
edges on the bottom of the unit. See Figure 4.
7. Set the upper section on the lower section.
8. Al ign the front and rear bolt holes of the upper
section with the bolt holes in the bottom section.
9. Insert a bolt and washer from the top down
througheachofthetwoholes.
10. Place a nut and washer on each of the bolts
and tighten securely.
11. Replace the oven side control compartments,
and close the front control panels on both
oven sections.
12. Place the top cap on top of the upper unit.
Upper Section
Lower Section
Crown Trim
Double stacked CTBR-AP shown
Top C a p
Gasket
Tap e
Figure 4