Programming instructions

OPERATION & CALIBRATION
1-45
Programming the Head Count:
1. The top display reads HEAd. The bottom display
gives the current number of heads programmed
for this product key. Use the product keys to enĆ
ter the desired number of heads from 1-99.
2. Press the SCAN KEY (14). The programming for
this recipe is now complete.
Exiting the programming mode:
1. The top display reads Prod. Press the PROG KEY
(9). The control returns to operating mode.
2ND LEVEL PROGRAMMING
Entering the programming mode
1. Press the PROG KEY (9). The top display reads
CodE.
2. Use the product keys to enter the programming
access code: 4 5 1 2. Press the ENTER KEY (13).
The top display reads SYS.
Programming hold
Hold allows product to be kept warm in the oven at
a programmed time and temperature. There are two
hold modes available, auto and manual. If auto hold
is enabled the control will automatically place the
oven into the hold mode at the end of each cooking
cycle. If manual hold is enabled the unit can be
placed into the hold mode at any time.
1. Press the SCAN KEY (14). The top display reads
Hold. Press the TOGGLE/CLEAR KEY (10) to
toggle between YES and no. Press the SCAN
KEY (14).
If no is chosen:
A.) The controller advances to programming the
setback mode.
If yes is chosen:
A.) The top display reads AUTO. Press the
TOGGLE/CLEAR KEY (10) to toggle beĆ
tween YES and no. Press the SCAN KEY (14)
to enter the desired hold mode.
B.) The top display reads HOLD. The bottom
display gives the current hold time. Press the
TOGGLE/CLEAR KEY (10). Use the product
keys to enter a hold time from 0 to 9 hours.
Press the SCAN KEY (14) to enter the new
hold time.
C.) The top display reads HOLD. The bottom
display gives the current hold temperature.
Press the TOGGLE/CLEAR KEY (10). Use
the product keys to enter a hold temperature
from 140_F-210_F. Press the SCAN KEY
(14) to enter the new hold temperature.
D.) The top display reads FAn. The bottom disĆ
play gives the current fan mode. To change
the fan mode press the TOGGLE/CLEAR
KEY (10). The bottom display toggles beĆ
tween Hi and Lo. Press the SCAN KEY (14)
to enter the new fan mode and continue with
programming the setback mode.