Programming instructions

CONVECTION OVEN CONTROLS
1-42
NOTE: An auto PreAlarm sounds for approxiĆ
mately 5 seconds, then shuts off autoĆ
matically. For manual PreAlarms the opĆ
erator must press the product key to
silence the alarm.
4. The top display reads A2__. Repeat steps 1-3
for the second and third PreAlarm. When all
PreAlarms have been entered the control adĆ
vances to programming the head count.
Programming the Head Count:
1. The top display reads HEAd. The bottom display
gives the current number of heads programmed
for this product key. Use the product keys to enĆ
ter the desired number of heads from 1Ć99.
2. Press the SCAN KEY (14). The programming for
this recipe is now complete.
Exiting the programming mode:
1. The top display reads Prod. Press the PROG KEY
(9). The control returns to operating mode.
PROGRAMMING MULTIPLE STAGE RECIPES
Entering the Programming Mode:
1. Press the PROG KEY (9). The top display reads
CodE.
2. Use the product keys to enter the programming
access code: 3 1 2 4. Press the ENTER KEY (13).
The top display reads Prod.
3. Press the desired product key followed by the
ENTER KEY (13).
Programming the Cook Time:
NOTE: If any stage of the product has a cook time of
greater than 59:59 the top display reads
Px-- for the product, stage and hours. The
bottom display counts down the cook time in
minutes:seconds.
1. The top display reads P1:__. The bottom display
gives the current programmed cook time for
stage 1 in minutes:seconds. Press the TOGGLE/
CLEAR KEY (10). Use the product keys to enter
the new cook time. Press the ENTER KEY (13) to
save the new cook time.
2. The top display reads P2:__. The control is askĆ
ing for the cook time for the second stage of this
recipe. Repeat Step 1 for each additional stage.
3. When the cook times for all stages are proĆ
grammed, press the TOGGLE/CLEAR KEY (10)
to clear the bottom display.
NOTE: This tells the controller that there are no
more stages for this recipe. Once the
number of stages has been established
the control will only allow entries for
these stages on all further parameters for
this product.
4. Press the ENTER KEY (13) again. The display
reads P1:. The bottom display shows the cook
time.
5. Press the SCAN KEY (14) to advance the proĆ
gramming mode to cook temperature.