Programming instructions

OPERATION & CALIBRATION
1-41
Programming the Fan Speed:
1. The top display reads SPd1. The bottom display
gives the current fan speed. Press the TOGGLE/
CLEAR KEY (10). The bottom display toggles beĆ
tween HI and Lo.
2. Press the SCAN KEY (14) to advance the proĆ
gramming mode to the fan cycle time.
Programming the Fan Cycle Time:
There are 3 options for fan cycle time: Pulse, Heat
and Full. Pulse allows the fan to turn on and off as
programmed. Heat allows the fan to operate with
heat only. Full provides continuous fan operation.
1. The top display reads CYC1. The bottom display
gives the current fan cycle. Press the TOGGLE/
CLEAR KEY (10). The bottom display toggles beĆ
tween PULS, HEAt and FULL.
2. If heat or full are selected press the SCAN KEY
(14) to save the new fan cycle and advance to
timing mode.
If pulse is selected press the SCAN KEY (14) and
continue with Steps 3-4 to program the pulse
cycle.
3. The top display reads on-1. The bottom display
gives the current pulse on time. Use the product
keys to enter the desired pulse on time from 10
to 60 seconds . Press the SCAN KEY (14).
4. The top display reads of-1. The bottom display
gives the current pulse off time. Use the product
keys to enter the desired pulse off time from 10
to 60 seconds. Press the SCAN KEY (14) to adĆ
vance the programming mode to timing mode.
Programming the Timing Mode:
There are 3 options for timing mode: Straight, Flex
and Sensitivity.
1. The top display reads tC-1. The bottom display
gives the current timing mode. Press the
TOGGLE/CLEAR KEY (10) to toggle between St,
FL and SEns.
2. If straight or flex are selected press the SCAN
KEY (14) to advance the programming mode to
PreAlarms.
3. If sensitivity is selected press the SCAN KEY (14)
and continue with Steps 4-5.
NOTE: Sensitivity adjusts the cook time to comĆ
pensate for any difference between the
setpoint and actual temperature. The
lower the sensitivity value the shorter the
time adjustment.
4. The top display reads SE-1. Use the product
keys to enter the desired sensitivity from 0Ć9.
5. Press the SCAN KEY (14) to advance the proĆ
gramming mode to PreAlarms.
Programming the PreAlarms:
A PreAlarm is an alarm that sounds during the cook
cycle. PreAlarms can be used to alert the operator
that the product needs to be turned or stirred, etc. Up
to three PreAlarms can be programmed for each
product.
1. The top display reads A1__. (The __ indicate the
product key) The bottom display gives the alarm
time. Use the product keys to enter the desired
time for the first alarm. Press the ENTER KEY (13)
to enter the PreAlarm time.
NOTE: PreAlarm times are measured from the
end of the total cook time. For example
if the total cook time is 30:00 and a PreAĆ
larm of 5:00 is entered, the alarm will
sound 25 minutes into the cook cycle. If
a PreAlarm of 0:00 is entered, no addiĆ
tional PreAlarms may be programmed
for the selected product key.
2. Press the SCAN KEY (14).
3. The top display reads AUTo. The bottom display
reads either YES or no. Press the TOGGLE/
CLEAR KEY (10) to toggle between YES and no.
Press the SCAN KEY (14) to enter the PreAlarm
type.