Corp. Electric Oven OPERATION 1200 SERIES

Installation
6
Oven Assembly
VENTILATION
1. Assemble the back vents.
2. Screw the back vent to the rear of each oven
section with the offset (enlarged) end toward
the bottom. Holes are provided. For stacked
units, the top of the lower back vent fits inside
the bottom of the upper vent.
3. Secure the trim to the top right of the upper
oven. The flanges on the right side, back and
front of the trim collar fit under the crown.
Usethreesheetmetalscrews toattach theleft
side of the trim t o the top of the oven body
4. Remove all tags.
Figure 4
ULTRA ROKITE DECKS
Use only Blodgett Ultra Rokite Decks. Use of
decks other than Blodgett will invalidate the
warranty.
NOTE: Ultra Rokite shelves are heavy be careful
when handling.
1. Slide 1/2 of the Ultra Rokite shelf through the
door until it rests on the deflector. Move the
shelftotherearuntilitdropsintotheshelfsup-
port. Push to t he right.
2. Slidethe remainings helf throughthe doorun-
til it rests on top of the other half. Move the
shelftotherearuntilitdropstheshelfsupport.
Push all the way to the left.
3. Move both shelves in so the center joint
closes.
4. Level with shims provided if necessary.
5. Refer to preheating instructions supplied with
shelf.
ELECTRICAL CONNECTION
Before making any electrical connections to this
unitcheck the ratingplate tobe surethat theoven
isbeing connectedtotheproper electricalsupply.
The supply conduit is connected to the right rear
of each oven section.
1. Remove the trim cover on the right lower front
of the oven to access the s upply connecting
terminals.
2. Run the supply wires through the conduit t o
the front of the oven.
3. Connectthesupplywirestothecircuitbreaker
on the lower right front corner of the control
panel.
NOTE: Whenusing aninterconnectionkit, referto
detailed instructions supplied with thekit.