Installation Instructions

®
/*Trademarks of Kimberly-Clark Worldwide, Inc. or its aliates. Marques déposées de Kimberly-Clark Worldwide, Inc. ou de ses filiales. © KCWW. T76L9C 7/17
STEP 1
Sweep clean and remove all debris from sub floor.
BLOCK-IT
*
Floor Underlayment Installation Instructions
STEP 2
Run the first sheet of Kimberly-Clark BLOCK-IT
*
Floor
Underlayment along the longest wall in the room positioning
the gray textured side facing up. If desired, place only enough
staples along the wall to keep Underlayment flat. Staples and/or
adhesive strips are not required on concrete sub floors.
STEP 3
Lay out each additional row of Kimberly-Clark BLOCK-IT
*
Floor
Underlayment with the additional row edge underneath the
previous row seams. Tape is not required on seams, but if
desired and/or Underlayment will not be covered by flooring
quickly, use an acrylic tape along the row seams of Floor
Underlayment to eliminate slipping.
STEP 4
Lay flooring directly over the top of Kimberly-Clark BLOCK-IT
*
Floor Underlayment according to flooring manufacturer
installation instructions.
ALL-IN-ONE FLOOR UNDERLAYMENT
• Recommended for all staple and nail down installation of solid and
engineered hard wood floors, laminate, or click-together vinyl
• Use over concrete and wood sub floors
• Noise dampening within the room and floors below
• Air circulation feature to dry any trapped moisture
• Helps prevent musty odors in the floor assembly
• Easy installation
• Can be installed in a double glue down application
• Can be installed over radiant heat that is under 200 degrees
• Made in the USA
• Coverage 100 sq. ft. / 36 in. x 33.34 ft. / 0.914 m x 10.16 m
STEP 1
Sweep clean and remove all debris from sub floor.
STEP 2
Run the first sheet of Kimberly-Clark BLOCK-IT
®
Floor
Underlayment along the longest wall in the room positioning
the gray textured side facing up. If desired, place only enough
staples along the wall to keep Underlayment flat.
STEP 3
Lay out each additional row of Kimberly-Clark BLOCK-IT
®
Floor
Underlayment with the additional row edge underneath the
previous row seams.
STEP 4
Lay flooring directly over the top of Kimberly-Clark BLOCK-IT
®
Floor Underlayment according to flooring manufacturer
installation instructions.
®/™ Trademarks of Kimberly-Clark Worldwide, Inc. or its affiliates. Marques de commerce de Kimberly-Clark Worldwide, Inc. ou de ses sociétés affiliées. © KCWW. T0KB1K 4/20
Excellent noise dampening
Use for commercial and residential applications