User manual

Page 9

USING THIS FIXTURE WITH THE wiCICLE® WIRELESS

DMX SYSTEM

In addition to the unbridled thrill you will experience the ﬁ rst time you

go sans power cord with your Puck: UNPLUGGED™ ﬁ xture, the Puck:

UNPLUGGED™ also works seamlessly with our wiCICLE® Wireless DMX

system, without additional power.

To use the Puck: UNPLUGGED with a wiCICLE® receiver, ﬁ rst, set the

ﬁ xture to slave mode by following the instructions on page 11. If the

ﬁ xture is not set to slave mode, you may experience interference as

the wiCICLE will attempt to retransmit the master signal being gener-

ated by the ﬁ xture.

After the ﬁ xture is set to slave mode, simply plug the wiCICLE®

receiver into the DMX IN connector on the back of the ﬁ xture. The

ﬁ xture will automatically detect and power the wiCICLE®.

Follow the instructions provided on the wiCICLE® instruction sheet to

select/change frequency groups:

· GROUP 1: RED

· GROUP 2: GREEN

· GROUP 3: YELLOW

· GROUP 4: BLUE

· GROUP 5: VIOLET

· GROUP 6: CYAN

· GROUP 7: WHITE

Check it out -- the group number corresponds with the “ID” number on

the Lightcaster® as well.

Repeat the steps above for each ﬁ xture which will use a wiCICLE®

receiver.

Notes: wiCICLE® transmitters have additional power requirements and

therefore cannot be powered directly from the ﬁ xture. You will need to

utilize the supplied AC/DC adaptor to drive wiCICLE® transmitters in

your system.

The wiCICLE® receiver takes power from the ﬁ xture’s battery pack,

and will therefore have a minimal impact in runtime of the ﬁ xture.