User manual

Page 10
The Puck™ Fab5 Skywire Manual Rev. A Copyright (c) 2013 Blizzard Lighting, LLC
4. OPERATING ADJUSTMENTS
NOTE: After making any change, the unit will return to the correct mode in about 10 seconds.
DMX Mode
Allows the unit to be controlled by any universal DMX controller.
1.)ThedefaultmodeforthextureisDMX,whichappearsas
Addr on the LED
Readout. Use the <ENTER> button then the <UP> and <DOWN> buttons to
choose a channel between
1 and 512. Press <ENTER>againtoconrm.
2.) To change between 3 and 6 channel DMX mode, select
ChNd, then press
<ENTER>. Select either
3Ch, 5Ch or 12Ch, then press <ENTER> again to
conrm.
Master/Slave Mode (Auto/Sound Active/Color Preset/Custom):
1.) Use standard DMX cables to daisy chain your units together via the DMX
connector on the rear of the units.
2.) Choose a unit to function as the Master. Select MAST. The master unit must be
therstunit.Finally,chaintheunitstogetherusingDMXcable.
Master
SLNd then NASt toconrm.
3.) Select slave function by using the <UP>/<DOWN>keystoreachSLAVinthe
Master/Auto menu on the slave units, and they will react in the same as the Master.
Slave
SLNd then SLAu toconrm.
NOTE: When a unit is set to slave and no master is connected,
Stby will
appear on the LED display.
4.)Onthemasterxture,usethe<UP>/<DOWN> keys to reach
SHND, which
allows you to select the following:
Sound active SoUn then <ENTER>toconrm.
Auto mode CoLo then Auto, then <ENTER>toconrm.
Color preset
CoLo then CoL 1 - CoL 31, <ENTER>
Color strobe
StCo then 0-255 (Slowest <-.-> Fastest)
then
CoL 1 - CoL 31, <ENTER>
To set a custom color in Master/Slave/Standalone Mode:
Using this function, you can select any color by adjusting the Red, Green, Blue, Amber and
White values from 0-255. You may also adjust the color balance of the xture.
Please note that modifying the values in this step will affect ALL modes, therefore
we recommend resetting all levels to their highest value (255) after using this mode.
1.) Select
NAnu from the control panel, then hit <ENTER>.
2.) Choose
rEd, GrEE, bLuE, ANbE or Uhit, then hit <ENTER> to
conrm.
3.) Using the <UP>/<DOWN> keys, select the color you wish to display by
varying Red/Green/Blue intensity between 0 and 255, then hit <ENTER>toconrm
each color choice.
4.) Select Color preset mode as instructed above, then select
CoL 15. then
<ENTER>toconrm.