Operating instructions

Page 12

3.5.6 RDM DMX Address Setup

1. Press and hold <MENUS> for 2 seconds to enter Menu Mode.

2. Rotate the PAN wheel to locate “05. RDM DMX Address setup”.

3. Press <ENTER>toconrm.

4. Rotate the PAN wheel to select YES or NO; If YES and you press

<ENTER> you will enter RDM operation.

5. The ProKontrol™ MH will search and show the number of RDM

devices.

6. Rotate the PAN wheel to select an RDM device; rotate the TILT wheel

to adjust the DMX address of the RDM device. Press <ENTER> to

conrm.

7. Press <SWAP> to switch the information of the selected device,

Press <DEL> to verify the selected device.

8. Press <ESC> to return to the main men

3.6 Manual Fixture Control

1. Press the <FIXTURE> button to activate FIXTURE mode.

2. Selectthedesiredxtureswiththenumberbuttons(1-16)andthe

PAGE button (PAGE A: 1-16, PAGE B: 17-32).

3. Move the faders and/or wheels to adjust the DMX output values. In

Step2,xturescanbeselectedonebyone;Alternatively,youcan

selectmorexturesinasingleoperation.Forexample,toselect

Fixture 1-8, you can press and hold the number button 1 and then

press the number button 8, Fixture 1-8 will all be selected. The same

canbeappliedtodeselectxtures.

3.7 Fade Mode

1. Press and hold <MENUS> for 2 seconds to enter Menu Mode.

2. Rotate the PAN wheel to locate “04. Fade mode”.

3. Press <ENTER>toconrm.

4. Rotate the PAN wheel to select ALL CHANNEL or ONLY PAN/TILT.

5. Press <ENTER>toconrmor<ESC> to return to the main menu.

3.8 Built-In Movement and Color Effects

There are 9 built-in “movements” in the ProKontrol™ MH, and 7 built-in color

macrosforLEDxtures.Beforerunningamovement,allxturesmustbe

patched correctly.

1. Press the <FIXTURE> button to enter FIXTURE mode (indicator on).

2. Selectthedesiredxtureswiththenumberbuttons(1-16)andthe

PAGE button (PAGE A: 1-16, PAGE B: 17-32).

3. Press the <MOVEMENT>buttontoactivatetheMOVEMENTmode.

4. SelectadesiredMOVEMENT/MACROwiththenumberbuttons(1-16).

5. Movement 1-9 is for the pan/tilt movement of moving heads. By

using the <SWAP> button, toggle through the options.