User manual

Page 8

3. SETUP

Fuse Replacement

CAUTION! The COBZilla™ COB RGB 5X5 Pixel Matrix utilizes a high-

output switch-mode power supply with an internal fuse. Under normal

operating conditions, the fuse should not require replacement. The

fuse is eld replaceable, however it is an advanced procedure suited

to qualied individuals. Should your COBZilla™ COB RGB 5X5 Pixel

Matrix™ fuse require replacement, please contact Blizzard Lighting for

instructions, or to return your unit for service.

Connecting A Bunch of COBZilla™ COB RGB 5X5 Pixel Matrix

Fixtures

You will need a serial data link to run light shows using a DMX-512

controller or to run shows on two or more xtures set to sync in mas-

ter/slave operating mode. The combined number of channels required

by all the xtures on a serial data link determines the number of x-

tures the data link can support.

Fixtures on a serial data link must be daisy chained in one single line.

Also, connecting more than 32 xtures on one serial data link without

the use of a DMX optically-isolated splitter may result in deterioration

of the digital DMX signal.

The maximum recommended cable-run distance is 500 meters (1640

ft). The maximum recommended number of xtures on a serial data

link is 32 xtures.

Data/DMX Cabling

To link xtures together you’ll need data cables. You should use data-

grade cables that can carry a high quality signal and are less prone to

electromagnetic interference.

applications. Standard microphone cables will “probably” be OK, but

note that they cannot transmit DMX data as reliably over long distanc-

es. In any event, the cable should have the following characteristics:

2-conductor twisted pair plus a shield

Maximum capacitance between conductors – 30 pF/ft.

Maximum capacitance between conductor & shield – 55 pF/ft.

Maximum resistance of 20 ohms / 1000 ft.

Nominal impedance 100 – 140 ohms