User manual

Page 13

DMX Mode

Allows the unit to be controlled by any universal DMX controller. If you are unfamiliar with

DMX, please read the DMX Primer on page #16.

The COBZilla™ COB RGB 5X5 Pixel Matrix is capable of operating

with 3, 5, or 75 DMX channels. To select the channel mode that you desire,

1:) Press the <MODE> button to select DMX address: 001 on the LED

Readout.

2:) Then press the <SETUP> button to select channel mode,

channels: 03, 05, 75 CHs. Use the <UP> or <DOWN> to select desired channel.

Auto, Master/Slave, Sound Active & Static Color Modes:

Allows a single or Master/Slaved units to run factory installed programs at user selectable

speeds.

1.) To set the xture to one of the Built-in Programs,

select RUN PROGRAM: 01-19 using the <MODE> button. Select desired

program by using the <UP> and <DOWN> buttons

2.) To set the program and Strobe setting, select SP: 001-100 FS: 000-100

using the <SETUP> button then the <UP> and <DOWN> buttons to

choose desired program/strobe function. Press the <MODE> button to

switch between settings.

3:) To use Auto Mode, Press the <MODE> button to reach

AUTO times: 001-100. Use the <UP> and <DOWN> buttons

to choose desired program

4:) To set the program speed and Strobe setting,

select SP: 001-100 FS: 000-100 using the <SETUP> button then the

<UP> and <DOWN> buttons to choose desired program/strobe function.

Press the <MODE> button to switch between settings.

Master/Slave Mode:

1:) Each xture is a master by default. To set the xture as a slave, use the

<MODE> button to reach SLAVE MODE

======================

2.) Press the <MODE> button to exit out of the menu.

Sound Active Mode:

1.) To use sound active mode, select SOUND TRIGGER by pressing <MODE>.

2.) Press the <SETUP> button to change the sensitivity 00-31 by using the

<UP> and <DOWN> buttons.

3.) Press the <MODE> button to exit sound trigger mode.

Color Static Mode:

1.) Press the <MODE> button to reach STATIC COLOR.

2:) Then press the <SETUP> button to set the color R255 G255 B255.

By using the <UP> and <DOWN> buttons, this allows you to

change each value. (000-255)

3.) Press the <MODE> button to exit static color mode.