User's Manual

Page 9
StormChaser™ Supercell Rev. A © 2020 Blizzard Lighting, LLC
Fixture Linking (M/S Mode)
1. Connect the male connector side of the DMX cable to the output female
connector of the rst xture.
2. Connect the end of the cable coming from
the rst xture which will have a female
connector to the input connector of the next
xture consisting of a male connector. Then,
proceed to connect from the output as stated
above to the input of the following xture
and so on.
A quick note: Often, the setup for Master-Slave and
Standalone operation requires that the rst xture in the
chain be initialized for this purpose via either settings in the
control panel or DIP-switches. Secondarily, the xtures that
follow may also require a slave setting.
Check the “Operating Adjustments” section in this manual for complete
instructions for this type of setup and conguration.
DMX OUTDMX IN
First
Fixture
in Chain
Next
Fixture
in Chain
DMX OUTDMX IN
Mounting & Rigging
This xture may be mounted in any SAFE position provided there is enough
room for ventilation.
It is important never to obstruct the fan or vents pathway. Mount the xture
using a suitable “C” or “O” type clamp. The clamp should be rated to hold at
least 10x the xture’s weight to ensure structural stability. Do not mount to
surfaces with unknown strength, and ensure properly “rated” rigging is used
when mounting xtures overhead.
Adjust the angle of the xture by loosening both knobs and tilting the xture.
After nding the desired position, retighten both knobs.
• When selecting installation location, take into consideration lamp
replacement access (if applicable) and routine maintenance.
• Safety cables MUST ALWAYS be used.
• Never mount in places where the xture will be exposed to rain, high
humidity, extreme temperature changes or restricted ventilation.
Lens Installation
To replace the lens, follow these steps:
1. Remove the locking knob, bracket, 4 screws,
and end cap on either of the two ends.
2. Loosening the screws on the opposite end can
allow the lens to slide easier, if needed.
3. Slide the existing lens out, and slide the
replacement lens in.
4. Reinstall the end cap, 4 screws, bracket, and
locking knob.