User's Manual

Page 12

DMX Mode

Allows the unit to be controlled by any universal DMX controller.

Starting DMX Address:

1.) Navigate the main menu until you reach Addr, and press the

<ENTER> button. Then use the <UP/DOWN> buttons to select a

starting DMX address ranging from 1-512, and press <ENTER>.

DMX Channel Mode:

1.) Navigate the main menu until you reach ChNd, and press the

<ENTER> button. Then use the <UP/DOWN> buttons to select 7ch,

20ch, or 52ch, and press the <ENTER> button to conrm.

M/S Mode:

1.) Daisy chain the DMX input/output connections of the xtures.

2.) On the 1st xture, navigate to Node and press <ENTER>.

3.) Then highlight NaSt, and then press the <ENTER> button.

4.) On following xtures, this setting should be set as DMX-512.

Auto Mode, Sound Active, & Manual Adjustments

Allows a single or daisy chained units to run factory installed programs.

Auto Programs:

1.) Navigate the menu until you reach Auto, and press <ENTER>.

2.) Use the <UP/DOWN> buttons to highlight Au 0 - Au59, and press

<ENTER> ("Au 0" cycles through all programs).

3.) Then use the <UP/DOWN> buttons to highlight a speed setting

from SP 1 - SP 9 (slow <-> fast).

4.) Press <ENTER>, and the program will start shortly.

Sound Active Mode:

1.) Navigate the menu until you reach SoUn, and press <ENTER>.

2.) Use the <UP/DOWN> buttons to Highlight Su-- (program), or Se--

(sensitivity), and press <ENTER>.

3.) To select a program, use the <UP/DOWN> buttons to select Su 0 -

Su59, and press <ENTER> ("Su 0" cycles through all programs).

4.) To adjust mic sensitivity, use the <UP/DOWN> buttons to select

from Se00 - Se99 (decrease <-> increase).

5.) Press <ENTER>, and the program will start shortly.

Preset and Manual Colors:

1.) Navigate to CoLo (preset) or Nanu (manual), and press <ENTER>.

2.) For preset colors, highlight Co 1 - Co 7 and press <ENTER>.

3.) For manual color mixing, adjust the Red, Green, and Blue intensity

levels from 0-255, and press the <ENTER> button.