Manual

Page 10
The Puck Vari White User Manual Rev. A Copyright (c) 2012 Blizzard Lighting, LLC
4. OPERATING ADJUSTMENTS
NOTE: After making any adjustment, hold the <MENU> button for approximately
3 seconds, otherwise the xture will return to the correct mode after approxi-
mately 10 seconds.
DMX Mode
Allows the unit to be controlled by any universal DMX controller.
1.)ThedefaultmodeforthextureisDMX,whichappearsas
Addr on the LED
Readout. Use the <ENTER> button then the <UP> and <DOWN> buttons to
choose a channel between
1 and 512. Press <ENTER>againtoconrm.
2.) To change between 2, 3 and 5 channel DMX mode, select
ChNd, then press
<ENTER>. Select either
5Ch, 3Ch, or 2Ch, then press <ENTER> again to
conrm.
Master/Slave Mode (Color Preset/Custom):
Allows you to link up to 32 units together without a controller.
1.) Use standard DMX cables to daisy chain your units together via the DMX con-
nector on the rear of the units.
2.) Choose a unit to function as the Master. Select MAST. The master unit must
betherstunit.Finally,chaintheunitstogetherusingDMXcable.
Master
SLNd then NASt toconrm.
3.) Select slave function by using the <UP>/<DOWN> keys to reach SLAV in
the Master/Auto menu on the slave units, and they will react in the same as the
Master.
Slave
SLNd then SLAu toconrm.
NOTE: Fixtures in slave mode will display “
STBY“ (Standby). This is NORMAL.
Return the xture to master mode to use it as a standalone xture.
To set a custom color in Master/Slave/Standalone Mode:
Using this function, you can select any shade of white by adjusting the White and Warm
White values from 0-255 and also apply a strobe effect.
Please note that modifying the values in this step will affect ALL modes, therefore
we recommend resetting all levels to their highest value (255) after using this
mode.
To enter color mode, select
CoLo from the menu panel and thenhit <ENTER> to con-
rm.Youcanthenadjustthefollowing:
Cool White Level
CooL then 000- 255, <ENTER>.
Warm White Level
UArm then 000- 255, <ENTER>.
Strobe Speed
Stro then 000- 255, <ENTER>.