SUITABLE FOR OUTDOOR USE Blizzard Lighting, LLC www.blizzardlighting.
TABLE OF CONTENTS TOURnado™ IP COB 1 1. Getting Started 3 What’s In The Box? 3 Getting It Out Of The Box 3 Powering Up! 3 Getting A Hold Of Us 3 Safety Instructions (Don’t Stick Your Hand In The Toaster!) 4 2. Meet The TOURnado™ IP COB 5 Features 5 DMX Quick Reference 5 The TOURnado™ IP COB Pin-up Picture 6 3.
1. GETTING STARTED What’s In The Box? • • • • 1 x TOURnado™ IP COB Professional LED PAR Fixture 1 x IP Rated AC power cord with cable cap 1 x Set of IP Rated DMX in/out cables This Lovely User Manual Optional Accessories (sold separately) The following accessories are available for this fixture. But the lone wolves that they are, they must be purchased separately.
SAFETY INSTRUCTIONS • Please keep this User Guide for future use. If you sell the unit to someone else, be sure that they also receive this User Guide. • ALWAYS make sure that you are connecting to the proper voltage, and that the line voltage you are connecting to is not higher than that stated on the decal or rear panel of the fixture. • Make sure there are no flammable materials close to the unit while operating.
2.
Figure 1: The TOURnado™ IP COB Pin-Up Picture Heavy-Duty Cast Aluminum Enclosure 80W RGB LED COB Light Source Secure Grip Locking Knobs Dual Adjustable Mounting Brackets Figure 2: The Rear Connections AC Power In AC Power Out DMX Out DMX In 4-Character LED Display Touch Sensitive Buttons LED Display Page 6 TOURnado™ IP COB User Manual Rev.
3. SETUP Fuse Replacement CAUTION! The TOURnado™ IP COB utilizes a high-output switchmode power supply with an internal fuse. Under normal operating conditions, the fuse should not require replacement. The fuse is field replaceable, however it is an advanced procedure suited to qualified individuals. Should your TOURnado™ IP COB fuse require replacement, please contact Blizzard Lighting for instructions, or to return your unit for service.
Cable Connectors Cables must have a male XLR connector on one end and a female XLR connector on the other end. (Duh!) CAUTION: Do not allow contact between the common and the fixture’s chassis ground. Grounding the common can cause a ground loop, and your fixture may perform erratically. Test cables with an ohm meter to verify correct polarity and to make sure the pins are not grounded or shorted to the shield or each other.
Fixture Linking (Master/Slave Mode) 1. Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin connector of the first fixture. 2. Connect the end of the cable coming from the first fixture which will have a (female) 3 pin connector to the input connector of the next fixture consisting of a (male) 3 pin connector. Then, proceed to connect from the output as stated above to the input of the following fixture and so on.
4. OPERATING ADJUSTMENTS The Control Panel All the goodies and different modes possible with the TOURnado™ IP COB LED are accessed by using the control panel on the rear of the fixture. There are 4 control buttons below the LED display which allow you to navigate through the various control panel menus.
Control Panel Menu Structure Addr d001 - d512 To choose the DMX address SLAU SLAu To run the fixture in slave mode CHnd 8CH 8 channel DMX mode 5CH 5 channel DMX mode 4CH 4 channel DMX mode nodE nod0-nod4 Dimming mode (0-4) SP -- SP00 -SP15 Speed adjustments (0-15) Pr -- Pr00 -Pr07 Built-in programs (0-7) ASC - AC00 -AC15 Auto mode (0-15) FAdE FA00 -FA15 Fade settings (0-15) FLAS FL00 -FL15 Flash / strobe speed (0-15) rL -- r000 - r255 Red dimmer (0% <--> 100
DMX Mode Allows the unit to be controlled by any universal DMX controller. Set the Starting DMX Address: The default mode for the fixture is DMX, so the first menu item that you can edit is the starting DMX address. 1.) 2.) 3.) 4.) Navigate the menu using the buttons until you reach Addr. Push the button. Use the buttons to select a DMX channel from 001-512. Press the button to confirm. Select the DMX Channel Mode: 1.) 2.) 3.) 4.
Dimming Mode Each allows for different amounts of steps for much smoother (and slower) dimming capabilities. 1.) 2.) 3.) 4.) Navigate the menu using the buttons until you reach nodE. Push the button. Use the buttons to select nod0-nod4. Press the button to confirm.
DMX Values In-Depth (4-Channel Mode) Channel Value What It Does 1 000 <--> 255 Red Intensity (0% <--> 100%) 2 000 <--> 255 Green Intensity (0% <--> 100%) 3 000 <--> 255 Blue Intensity (0% <--> 100%) 000 <--> 010 011 <--> 255 Strobe Strobe Off Strobe (Slow <--> Fast) 4 Troubleshooting Symptom Solution Fixture AutoShut Off Check the fan in the fixture. If it is stopped or moving slower than normal, the unit may have shut itself off due to high heat.
5. APPENDIX A Quick Lesson On DMX DMX (aka DMX-512) was created in 1986 by the United States Institute for Theatre Technology (USITT) as a standardized method for connecting lighting consoles to lighting dimmer modules. It was revised in 1990 and again in 2000 to allow more flexibility. The Entertainment Services and Technology Association (ESTA) has since assumed control over the DMX512 standard. It has also been approved and recognized for ANSI standard classification.
Keeping Your TOURnado™ IP COB As Good As New The fixture you’ve received is a rugged, tough piece of pro lighting equipment, and as long as you take care of it, it will take care of you. That said, like anything, you’ll need to take care of it if you want it to operate as designed. You should absolutely keep the fixture clean, especially if you are using it in an environment with a lot of dust, fog, haze, wild animals, wild teenagers or spilled drinks.
Tech Specs! Weight & Dimensions Width 10.5 inches (26.5 cm) Depth 7.4 inches (18.7 cm) Height 8.1 inches (20.5 cm), 11.3 inches (28.6 cm) including bracket height Weight 8.82 lbs (4 kg) Power Operating Voltage AC 100V-264V/47-63HZ Power Consumption 80-Watts Light Source LED 1x 80W RGB COB LED Optical Beam Angle 60 degree Luminous Intensity TBA Thermal Max. Operating Temp.
Dimensional Drawings 11.3 in (285.7 mm) 8. 1 in (2 05 m m ) 10.5 in (265.1 mm) 8.3 in (209 mm) 7.4 in (187 mm) Page 18 TOURnado™ IP COB User Manual Rev.
This page intentionally left blank. Page 19 TOURnado™ IP COB User Manual Rev.
Enjoy your product! Our sincerest thanks for your purchase! --The team @ Blizzard Lighting