User guide

Page 10

4. OPERATING ADJUSTMENTS

NOTE: After making any adjustment, hold the <MENU> button for approximately

3 seconds, otherwise the xture will return to the correct mode after approxi-

mately 10 seconds.

DMX Mode

Allows the unit to be controlled by any universal DMX controller.

1.) The default mode for the xture is DMX, which appears as Addr

on the LED

Readout. Use the <ENTER> button then the <UP> and <DOWN> buttons to

choose a channel between

1 and 512. Press <ENTER> again to conrm.

2.) To change between 4 and 7 channel DMX mode, select

ChNd, then press

<ENTER>. Select either

7Ch or 4Ch, then press <ENTER> again to con-

rm.

Master/Slave Mode (Auto/Sound Active/Color Preset/Custom):

Allows you to link up to 32 units together without a controller.

1.) Use standard DMX cables to daisy chain your units together via the DMX con-

nector on the rear of the units.

2.) Choose a unit to function as the Master. Select MAST. The master unit must

be the rst unit. Finally, chain the units together using DMX cable.

Master

SLNd then NASt to conrm.

3.) Select slave function by using the <UP>/<DOWN> keys to reach SLAV in

the Master/Auto menu on the slave units, and they will react in the same as the

Master.

Slave

SLNd then SLAu to conrm.

NOTE: Fixtures in slave mode will display “

STBY“ (Standby). This is NORMAL.

Return the xture to master mode to use it as a standalone xture.

4.) On the master xture, use the <UP>/<DOWN>

keys to reach SHND, which

allows you to select the Master/Slave mode.

Sound active

SoUn then <ENTER> to conrm.

Auto mode

CoLo then Auto, then <ENTER> to conrm.

Color preset

CoLo then CoL 1 - CoL 15, <ENTER>.

Fade Mode

FAdE then SP 1 - SP 8, <ENTER>.

NOTE: Speed 1 = Fastest (Approx. 1.5 sec. per color), Speed 8 = Slowest (Approx.

2 min. per color).