User Manual

Page 7

3. SETUP

Fuse Replacement

CAUTION! The Puck Pro Zoom™ EXA utilizes a high-output switch-

mode power supply with an internal fuse. Under normal operating

conditions,thefuseshouldnotrequirereplacement.Thefuseiseld

replaceable,howeveritisanadvancedproceduresuitedtoqualied

individuals. Should your Puck Pro Zoom™ EXA fuse require replacement,

please contact Blizzard Lighting for instructions, or to return your unit for

service.

Connecting A Bunch of Puck Pro Zoom™ EXA Fixtures

You will need a serial data link to run light shows using a DMX-512

controllerortorunshowsontwoormorexturessettosyncinmaster/

slave operating mode. The combined number of channels required by all

thexturesonaserialdatalinkdeterminesthenumberofxturesthe

data link can support.

Fixtures on a serial data link must be daisy chained in one single line.

Also,connectingmorethan32xturesononeserialdatalinkwithout

the use of a DMX optically-isolated splitter may result in deterioration of

the digital DMX signal.

The maximum recommended cable-run distance is 500 meters (1640 ft).

Themaximumrecommendednumberofxturesonaserialdatalinkis

32xtures.

Data/DMX Cabling

Tolinkxturestogetheryou’llneeddatacables.Youshouldusedata-

grade cables that can carry a high quality signal and are less prone to

electromagnetic interference.

applications. Standard microphone cables will “probably” be OK, but note

that they cannot transmit DMX data as reliably over long distances. In

any event, the cable should have the following characteristics:

2-conductor twisted pair plus a shield

Maximum capacitance between conductors – 30 pF/ft.

Maximum capacitance between conductor & shield – 55 pF/ft.

Maximum resistance of 20 ohms / 1000 ft.

Nominal impedance 100 – 140 ohms