User guide

Page 8

3. SETUP

Fuse Replacement

Withaatheadscrewdriver,wedgethefuseholderoutofits

housing. Remove the damaged fuse from its holder and replace

with exact same type fuse. Insert the fuse holder back in its

place and reconnect power.

Connecting A Bunch of Puck™ Fab5 Flat LED PAR Cans

You will need a serial data link to run light shows using a DMX-

512controllerortorunshowsontwoormorexturessetto

syncinmaster/slaveoperatingmode.Thecombinednumberofchannelsrequiredbyallthexturesona

serialdatalinkdeterminesthenumberofxturesthedatalinkcansupport.

Fixturesonaserialdatalinkmustbedaisychainedinonesingleline.Also,connectingmorethan32x-

tures on one serial data link without the use of a DMX optically-isolated splitter may result in deterioration

of the digital DMX signal.

The maximum recommended cable-run distance is 500 meters (1640 ft). The maximum recommended

numberofxturesonaserialdatalinkis32xtures.

Data/DMX Cabling

Tolinkxturestogetheryou’llneeddatacables.Youshouldusedata-gradecablesthatcancarryahigh

quality signal and are less prone to electromagnetic interference.

Forinstance,Belden©9841meetsthespecicationsforEIARS-485applications.Standardmicrophone

cables will “probably” be OK, but note that they cannot transmit DMX data as reliably over long distances.

In any event, the cable should have the following characteristics:

2-conductor twisted pair plus a shield

Maximum capacitance between conductors – 30 pF/ft.

Maximum capacitance between conductor & shield – 55 pF/ft.

Maximum resistance of 20 ohms / 1000 ft.

Nominal impedance 100 – 140 ohms

USING THIS FIXTURE WITH THE wiCICLE® WIRELESS DMX SYSTEM

Inadditiontotheunbridledthrillyoualreadyreceivedthersttimeyoupluggedin

yourxture,you’llbedelightedtoknowthatThisxturealsoworksseamlesslywithour

wiCICLE®WirelessDMXsystem,withoutadditionalpower.

•ONLYxturesbearingthislogoarecertiedforusewiththewiCICLE®withoutexternal

power.

•Unauthorizedmodicationand/orusingthewiCICLE®with

unapprovedxturesmaycausedamagetothewiCICLE®or

xture.UNDERNOCIRCUMSTANCESISBLIZZARDLIGHTING

RESPONSIBLE FOR ANY DAMAGE FROM SUCH OPERATION.

•FixturesbearingtheabovelogoMUSTonlyusecableandconnectorswhichseparate

chassis/case ground from cable shielding. Cabling with the shield connected to the connec-

tor’scase/chassismaycausemalfunctionanddamagetothewiCICLE®orxture.

•wiCICLE®transmittershaveadditionalpowerrequirementsandthereforecannotbe

powereddirectlyfromthexture.YouwillneedtoutilizethesuppliedAC/DCadaptorto

drivewiCICLE®transmittersinyoursystem.